mortar

Mortars based on resins, which are defined as anti-corrosion resins, are another group of mortars that are used when resistance to various chemical loads is required. In general, this type of mortar is based on a binder resin that is hardened by a hardener.

The most important resins used in anti-corrosion mortars are: phenolic resins, furan resins and epoxy resins in combination with polyamine hardeners and unsaturated polyester and vinyl ester resins.

Technical specifications of aluminum refractory mortar

Aluminum mortar is a combination of ceramic materials with proper granulation and mineral binders. which is made on the basis of water and specially formulated for insulating bricks. Insulation bricks have a high absorption rate due to high porosity.Therefore, their porcelain refractories are done with the usual two-component mortar with many problems.

Due to its special and unique formulation, ready-to-use mortar provides proper strength after drying and curing, while increasing the working time. Meanwhile, this mortar is also used for heavy and dense refractory bricks.Application of aluminum refractory mortar
Repair of smelting furnaces in iron and steel and foundry
The place of transportation of repair melt transport devices
Slag storage place
Ramp of coking ovens
The floor of waste halls such as chemical food industries
Iron and steel that are subject to impact corrosion and wear
Emergency repair of machinery foundation
Advantages of refractory mortar
High mechanical strength
Anti-shock and anti-wear
High temperature tolerance during repeated cold heating up to 1100 degrees
Preparation of aluminum refractory mortar

Before using the mortar, it is necessary to mix it for a few minutes with a suitable mixer, until the mortar reaches a creamy state. The concentration of this mortar is formulated for troweling. If it is intended to be used by immersion method, it is necessary to add a percentage of water to its composition and mix it again.When mixing mortar, it should be noted that the mixer and containers used are completely clean and free of any contamination. It is necessary to remember to close the lid of the corresponding container and seal it completely to prevent water evaporation.

Also, in special cases, it is possible to need thicker or thinner mortar or mortar with special analysis (for example, phosphate mortar, alumina mortar, silicon mortar, etc.).

Tips about aluminum refractory mortar

The conditions that mortars deal with are more difficult and therefore require carefully adjusted properties. This mortar must be workable and trowelable.

If strong joints are required, the refractory mortar must be sufficiently heated to form a strong ceramic bond, but the refractory properties of the mortar must be high enough to resist melting or flowing from the joints at high temperatures.How to choose refractory mortar?

The conditions that mortars deal with are often very harsh and therefore require carefully tuned properties. In terms of economy and easier installation of brickwork, a mortar should have workability, troweling ability and good working properties. A refractory mortar with proper performance and excellent water retention in a range of concentration can be used for masonry joints and screed boards such as wall surface coating or for patching and repair.

If strong joints are required, the refractory mortar must be sufficiently heated to form a strong ceramic bond. But the refractory properties of the mortar must be high enough to resist melting or flowing from the joints at high temperatures.Refractory materials used in the mortar of Yekta Zayandeh Rood Industrial Refractory Products are used in the construction of many furnaces and other things and can be used to arrange bricks, a neutral layer between each type of brick, to prevent slag invasion and corrosion, etc. It is applicable